Masonry Take Off Software

Manage your take offs in 5 easy steps!

1)      Enter your materials used.

2)      Setup Models and options

3)      Assign Models and Options to your Job

4)      One click to calculate all materials

5)      Point and click to send a PO to you supplier.

Step 1 - Enter your materials used.

Take Off’s made easy!

This simple form allows you to setup all the materials you will use.

It’s like have a Rolodex® for your materials that you use everyday.

Step 2 - Setup Models and options

Tracking the materials needed on your jobs has never been easier.

After you do a one time setup of your models, you can do in seconds what used to take hours.

You setup the needed block counts, yards of sand and other materials to make it all come together.

Step 3 – Assign Models and Options to your Job

The Take Off Detail feature allows you to quickly pull together the material list you will need. 

The best part of this feature is you can see instantly the changes in your block materials.  As you add options, like a garage door, side door, etc. the calculations of materials are done for you!

Step 4 – Updates and changes to material counts are easy!

One click and all material calculations are done without any mistakes!